Naze32 & Minim OSD items not working

[andythilo]

Hi

Has anyone got armed/unarmed and throttle percentage working?

Cheers

Andy

Sent from my SM-P605 using Tapatalk

[Hands0n]

Andy - have a read through this webpage on the MultiWii/Naze CLI variables ...

https://github.com/multiwii/baseflight/wiki/CLI-Variables

Specifially around mincheck/maxcheck

These are min/max values (in us) which, when a channel is smaller (min) or larger (max) than the value will activate various RC commands, such as arming, or stick configuration. Normally, every RC channel should be set so that min = 1000us, max = 2000us. On most transmitters this usually means 125% endpoints. Default check values are 100us above/below this value.

[weavo56]

One thing I have noticed is with minimOSD on the rx tx pins in the middle of the naze32  the osd works ok till u arm the board then it freezes on the screen . found out that you have to disable TELEMETRY in the cli  to get it to work .  So no info on your Tx .
Don';t know why though .

Graham

[kilby]

What firmware are you using on the minimosd?

I installed MW osd and it simply worked straight out of the box (even the battery voltage is right)

[Vyizis]

Having had a similar issue when I was trying to make mine work yesterday, I expect the issue is having telemetry on. The telemetry port and rx/tx ports share serial port 1 to the chip and will conflict, this is the same reason you only get telemetry data when the board is armed.

You can make telemetry work if you switch to using soft serial and moving the port in the CLI.