Rabbit Flight Controller v1.220 Firmware Test With 3d Mode Enabled

[Gaza07]

I had a chance to test the Rabbit a bit more with the 3d mode enabled  and I have to say it works very well    I just need to learn to add a bit of throttle at the right time to stop it dropping as it comes out of the flip, I also tested the height hold and gps postion hold which also worked perfectly, I tried carefree and for the for time set the declination which actually seemed to knock it a little out of wack so will remove that for the next flight, but carefree still worked ok.

I over corrected while under the washing line and it flipped and landed total accident and very lucky im not repairing it   


http://youtu.be/umRm64nnN-8

[Biffa]

Looks good

Not sure I';d stick my hand in between the 4 blades though

[Gaza_07]

I wouldnt if I didnt feel it was stable enough 

Looks good

Not sure I';d stick my hand in between the 4 blades though

[Jumpy07]

I had a chance to test the Rabbit a bit more with the 3d mode enabled  and I have to say it works very well    I just need to learn to add a bit of throttle at the right time to stop it dropping as it comes out of the flip, I also tested the height hold and gps postion hold which also worked perfectly, I tried carefree and for the for time set the declination which actually seemed to knock it a little out of wack so will remove that for the next flight, but carefree still worked ok.

I over corrected while under the washing line and it flipped and landed total accident and very lucky im not repairing it   

Nice flying Gary.. well impressed..


http://youtu.be/umRm64nnN-8

[Gaza07]

Thanks for the comments Jumpy its more the controller than me, the flips are done by the rabbit in its 3d / stable mode, I  just need to learn a bit better throttle control to loose less height but it works well