3d Printing Service
Printing 3d Forum
Started by teslahed, Wednesday,November 14, 2012, 11:22:02
Quote from: teslahed on Wednesday,November 14, 2012, 11:22:02 I';ve just bought myself two of these;http://www.hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=29039as after doing a bit of reading around I';ve discovered they are compatible with the standard turnigy9x transmitter and the er9x firmware mod which I';m running.I';ve just tested one and they are definitely compatible despite saying ';Compatible only with HobbyKing T4A & T6A Version 2 transmitters'; on the hobbyking website.
Quote from: bomber on Sunday,March 03, 2013, 10:13:03 Hi Chris,I bought one of these recievers,and it works perfectly with the 9x....but do you know how to set the failsafe,or if you can...at the moment when i switch off the TX,the motors stop,which is ok,but wouldnt mind being able to set them.something just below hover..so it lands a bit softer!:-)
Page created in 0.151 seconds with 42 queries.