3d Printing Service
Printing 3d Forum
Started by Gaza07, Thursday,November 08, 2012, 15:58:12
Quote from: Biffa on Thursday,November 08, 2012, 19:58:36 Looks good Not sure I';d stick my hand in between the 4 blades though
Quote from: Gaza07 on Thursday,November 08, 2012, 15:58:12 I had a chance to test the Rabbit a bit more with the 3d mode enabled and I have to say it works very well I just need to learn to add a bit of throttle at the right time to stop it dropping as it comes out of the flip, I also tested the height hold and gps postion hold which also worked perfectly, I tried carefree and for the for time set the declination which actually seemed to knock it a little out of wack so will remove that for the next flight, but carefree still worked ok.I over corrected while under the washing line and it flipped and landed total accident and very lucky im not repairing it Nice flying Gary.. well impressed..
Page created in 0.345 seconds with 43 queries.