3d Printing Service
Printing 3d Forum
Started by Jumpy07, Sunday,October 21, 2012, 19:19:17
Quote from: Phil1970 on Sunday,August 25, 2013, 07:24:18 Same problem as John, wired correctly but no sync in gps/arming/disarming.I think it';s because we have a aiop V2 board. On the v2, pin 32 is not actually a pin, but a solder (tiny)pad.I saw a post on another forum where that pin/pad "32" was adressed as "42" in the mpng code.I';ll post my findings when I get the leds and the buzzer working on the V2.
Quote from: Phil1970 on Sunday,August 25, 2013, 17:29:46 I am a bit confused here. In the picture from lakis I notice the wires to the ULN2803A are (on a aiop v1) nrs 5 ans 6.Still, in the code you are using A2 and A4. Should';nt that be A5 and A6?
Page created in 0.158 seconds with 43 queries.