Welcome to Multi-Rotor UK. Please login or sign up.

Friday,January 24, 2020, 03:43:30

Login with username, password and session length


Rares Gosav:
17 Jan 2020 17:44:22
Hi guys and happy new year!!!
01 Jan 2020 00:12:50
Happy new year everyone, happy flying.  :beer2: :beer2:
31 Dec 2019 17:06:13
Happy new year all hope 2020 is a cracking year for you  :beer2:
25 Dec 2019 00:00:49
Happy Christmas to everyone.
24 Dec 2019 13:50:56
Seasons greetings to all on this forum have a good one ;)
21 Dec 2019 17:58:42
Have a great time DB. Look forward your projects in 2020.  :beer2:
21 Dec 2019 16:59:17
Have a good one D.B. ~~ :beer2: :beer2: :beer2:
21 Dec 2019 16:14:27
21 Dec 2019 16:13:44
Tbh I've been really busy, not had much time to fly anything and with conditions being crap, hopefully in the new year I'll have some new projects on the go, mostly to do with HAM radio, will certainly fly again soon. FTR I hate FB too   :D Merry Christmas
21 Dec 2019 15:21:30
Merry Christmas  :beer2:
  • Total Posts: 197485
  • Total Topics: 19929
  • Online Today: 18
  • Online Ever: 530
  • (Tuesday,June 26, 2012, 08:34:46 )
Users Online
Users: 0
Guests: 17
Total: 17

Theme Changer


3d - Printworx

Printing 3d Forum

Step by step flashing your Immersion EzOSD and Current Sensor

Started by goraplx, Sunday,October 21, 2012, 11:00:12

Previous topic - Next topic


1. Download the latest ImmersionRC update/config tool v1.22
   - if you had 1.21 before you have to remove first before install 1.22.
2. Download sensor calibration firmware from "Current Sensnor" section in application ( EzOSDSensorCalibrationFirmware.fw )
3. Hold the middle button on OSD and connect to the USB port.
4. Update firmware "EzOSDSensorCalibrationFirmware.fw" to the OSD
5. Disconnect USB cable
6. Connect the main battery as first with your RC toy , and hold the middle button on OSD and connect to the USB
- you will see EzOSD not detected but its ok.
7. Go to section "Current Sensor" and click "Sensor Diagnostic and Calibration for End Users"
- measure battery voltage with your battery checker/monitor using balance port
- write this Voltage in "Measured Voltage" window like xx,xx not xx.xx (use comma not dot).
9. Disconnect all
10. Again Point no.3
11. Write firmware "EzOSD v1.14.fw" or 1.2 whatever you use in your OSD
12. Disconnect battery and USB cable.
13. Thats all
DJI F550 Hexa Naza & GPS
JR XG8 , Graupner 9" Props
LifePO4 - A123 5S1P 2300-2500mAh ANR26650M1A and B cells
GoproHD2 , Fatshark Rx, ImmersionRC Tx 600mW, Fatshark Dominator, SpiroNet set Antenna, EzOSD+CurrentSensor