Phoenix Simulator

[ericb]

Is anyone flying the quad on this and what Transmitter are they using. I bought a chinese version but the adaptor doesn';t work with my turnigy.....so looking for cheap tranny......anyone help.

Eric

[twinrotor2]

I use Phoenix simulator and use an old JR transmitter X-347 they can be picked up for very little on ebay



Jim

[kilby]

Using it with a DX7s though to be honest it';s the planks that I mostly play with

[ericb]

Do these Trannies have just a jack to plug in at the back ? They give you several adaptors

[kilby]

For most yes, they plug into the training port.

Of course every brand uses a different connector

[nub]

not used Phoenix in a longtime, the quads aren';t up to much from what i remember of them its more for heli practice IMO.

i used a cheapo £20 USB Tx

[guest325]

+1 planks not much better either, helis are very good though!

[ericb]

Just tried again and got the tranny to work........needs some better setup

[flybywire]

Have you seen these?
http://www.simstick.co.uk

U need a spare rx to connect, but once done, no cable!
I think it';s brill if you spend a lot of time on the sim.
Andy

[kilby]

Hobbyking do one that let';s you use most any make of receiver too.

I just bought a 10 quid wired one off Amazon though