interesting cable for the 600tvl

[Britishguy]

so ive been making up some, what i like to think professional cables that are made for the 600 tvl and include a built in mic, so far they work great.

Anyway i came across this after looking for some more 600tvl cables

http://www.securitycamera2000.com/products/3-Pin-1.25mm-Video-Power-Cable-for-DC-5V-to-DC12V-for-Board-Camera.html

step up? be pretty sweet as you can use the vtx 5v output

[Col_M]

Indeed, I didn';t know they had a cable section otherwise I';d have ordered this
http://www.securitycamera2000.com/products/3-pin-1.25mm-Female-to-3-pin-2.54mm-Female-Servo-Connector-Cable-30cm.html
for connecting my cam to the OSD when I ordered the camera.

Just be aware of the pin order on the servo end, for the minim OSD that I am using you need the pin order to be YRB instead of YBR as it comes from securitycamera2000. You';ll need to pop the red and black pins out and switch them over but this is very simple.

[Britishguy]

typical too as ive bought the dead cat bec to power the camera now

but then i need a 12v to power the mic and tapping into this might overload it, could buy 2 i suppose

damn dont know what to do now lol

[Gav]

Nice find. 

Yeah making use of the 5v out from the vtx is a good thing.

I use thin coax in place of the yellow cable and black gnd, between cam and vtx.  Not sure what type of cable it is exactly as I';ve had a reel of it for donkeys, but it';s thinner and lighter than rg316. Even though it';s a short distance between cam and vtx, it made a big difference and helped remove diagonal lines/ noise on the video feed on my setup even with filters. 
Twisting the cables can also help combat noise.