3d Printing Service
Printing 3d Forum
Started by jimbo385, Sunday,September 29, 2013, 09:37:25
Quote from: Hands0n on Sunday,September 29, 2013, 18:59:55 OK, you';ve convinced me - I';m going to plant my KK2 in the Teslaquad. But before I do I';ll put the 1.6++ firmware on. But which version?There seem to be three versions, 1.6++, 1.6++ CPPM and 1.6++ S.Bus. Obviously I won';t be using S.Bus but which of CPPM or just vanilla 1.6++ is the right one (Spektrum RX).
Quote from: DarrellW on Sunday,September 29, 2013, 19:46:56 Just use r1 of 1.6++, set one up Friday with it and it';s really good but bear in mind that all of your settings will be wiped out and you will have to recalibrate esc';s (which is dead easy now, no need for tx to be on, have a look at the release notes). Absolutely superb, very stable in stable mode, acro mode a bit tame but a safe starting point).
Quote from: Hands0n on Sunday,September 29, 2013, 19:49:55 Thanks Darrell, I';ve just burned that in to the KK2. Also found this good item by the software developer http://www.rcgroups.com/forums/showthread.php?t=1899326 It explains a lot of whats going on in there and how to select the appropriate SL MIXI';ll start taking the Teslaquad apart in the week - hope to get it re-maidened at the weekend then.
Page created in 0.635 seconds with 42 queries.