3d Printing Service
Printing 3d Forum
Started by steadiworkz, Tuesday,September 17, 2013, 18:32:37
Quote from: peter_a on Tuesday,September 17, 2013, 19:08:22 The hard bit is setting U port on the Naza .I set switch SA as a source on channel 5 on the mixer with 100% , and a second mix with the source of switch SF , SF down , 57% ( Replace ) which is the failsafe.The other bit is setting the Servo limits for channel 5 which is :- CH5 , U , -3.6 , -6.9 , 60 INV 1500 ^ Try looking at these videos :-https://www.youtube.com/user/PagesFlyingCircus/videos <- The taranis ones ( openTx )
Page created in 0.241 seconds with 42 queries.