3d Printing Service
Printing 3d Forum
Started by iWolf51, Saturday,July 20, 2013, 06:45:06
Quote from: DarrellW on Saturday,July 20, 2013, 07:31:34 Looks a very neat and tidy installation, wish mine was that tidy - looks like a rats nest by comparison ::) ::) ::)
Quote from: sevet on Wednesday,July 24, 2013, 17:21:36 Your setup looks real neat.The problem is: putting the Crius (?) board on the esc like this, might really kill your compass performance..... although i did read somewhere that the quatro is one of the most interference isolated as the wires connections inside are really short.Compass problems will give you unpredictable loiter, RTL and Simple mode in megapirateng, will you be using megapirateng?Also, if MPNG will be used, I saw you mounted the FC directly, you should consider mounting it on some vibration isolation pads.And lastly, don';t forget to cover your barometer with some kind of sponge, beware not to glue the small hole on it.What will you be doing with it? for 3S battery i would suggest 10" props. I don';t fly hard so I go with 5000mah battery, the 2200 lasts me only about 6-7 minutes but the response is better as it is lighter.
Quote from: DarrellW on Friday,July 26, 2013, 12:46:32 Make yourself a bracket to raise it a couple of inches, should work much better!
Quote from: barneyg on Friday,July 26, 2013, 13:51:08 Def makes a difference ... I';ve not done it yet but I changed from a power distribution board to a v2 baseplate with it built in and raised the dc as far as I could with the pins sticking up and my mag interferance changed from about 35degrees @ wot to 1 or 2 degrees
Page created in 0.131 seconds with 43 queries.