Crius aiop v2 using extend power on tri - no servo power?

[Bking1340]

Good day all
I`m using a external bec to power the crius v2 board with all 3 esc`s red wire removed. How will I get power to my servo?

Edit: Like I said, all 3 esc`s red wires are removed. Is it possible to connect the servo red wire to any one of those 3 and leave the signal with black wire connected to board on all 3 esc`s and servo?

[Gaza07]

Yea you should be able to take the power from any of the red esc wires to power the servo, If your running from an external Ubec with the jumper removed and one of the red esc wires still conected to the AIOP there should still be power at the servo / motor pins or there was on a V1 I have never had a V2 but would imagine its the same, all the 5v pins in the row should be connected together 

[Bking1340]

Thanks Gaza
Have just replaced one of the esc`s red\power wire and now there`s power to my servo - And tri is flying beautifully.
External power still connected and jumper still removed

[JerryCampbell]

I have a UBEC for external power in, the jumper removed, and all the wires on my esc';s hooked up.
Nothing gets hot and it flies great. I have a few hours on this setup.
jerry