3d Printing Service
Printing 3d Forum
Started by ericb, Friday,July 12, 2013, 11:32:50
Quote from: ericb on Friday,July 12, 2013, 15:42:04 I always copy and paste the libraries from Arducpoter into Arduino, then alter the bits, set GPS to UBLOX and click the arrow......it then runs through the process and shows the error above. I';ve tried using various versions but no.........Is there a way to clear all the data from the Crius board and start again ?
Quote from: Gav on Friday,July 12, 2013, 18:01:07 Try downloading the most up to date Arduino software 1.0.5. It might have some additional libraries used on the sketch you';re trying to run. http://arduino.cc/en/Main/Software
Quote from: ericb on Saturday,July 13, 2013, 11:21:09 Could you point me in the right direction for that. I had a look on Arduino, and I see what you , but don';t know how to find that.Cheers
Quote from: ericb on Saturday,July 13, 2013, 15:08:30 Thanks for talking the time to help me here. I tried that and still the same error.
Page created in 0.190 seconds with 44 queries.