TBS discovery current sensor to AIOP board

[krtek2k]

Hallo , i feel still like totaly noob in this.
I have ordered TBS up and bottom plate of their discovery , and i will be glad to achieve connection of built in current sensor to my AIOP board. Have anyone experience with it? Or similiar current sensor to our board?
Thank You.

[robshaw]

You can use the current sensor but the voltage sensor needs to be stepped down which the core would normally do. Current is fine tho.

Just solder some headers to the corresponding current sense pin where the core would normally be then connect it to the analogue input pin you have setup for current monitoring.

Only problem is the TBS is a 50A sensor and the crius looks for 45A or 90A. Which means I don';t think it will be very accurate.

Unfortunately also its no use without voltage really. You can step down the voltage with a couple of resistors but I';ve not got that far yet.

[krtek2k]

Ok , thank You.
I still dont have my plates at home , so i will know more , after i can look at it. I already have resistor to read voltage to my board next to minim OSD. I am still curious which outputs have TBS Discovery plates current sensor. If it is connectable by RX TX VCC GND four wires , or how. We will see.