Turnigy 9x & RX question

[davethepitch]

Hello all

I have purchased a Turnigy 9x transmitter and it came with a 9X8Cv2 RX with just CH numbers on it but on my Orange RX the pins are labeled like below.

BATT / bind
THRO
AILE
ELEV
RUDD
GEAR
AUX 1

My Turnigy RX just states the following:
CH1
CH2
CH3
CH4
CH5

CH6
CH7
CH8
BIND BAT

My question is which connectors from below go to the corresponding channels on the Turnigy RX.

THRO
AILE
ELEV
RUDD
GEAR

Thanks Dave

[Jumpy07]

What software does the 9X have on it ?

Reason I ask.. is if is ER9x etc.. you can just allocated the channels yourself on the TX

[davethepitch]

Hello Jumpy07

I am still trying to understand the Turnigy 9X transmitter and it has V2 firmware if that means anything to you but all i know is that the UK supplier i had it from stated the below in their advert.

Important.
The TURNIGY 9X has been reflashed with the new v2 firmware, fixing previous menu and mixing issues. This firmware flash is only available from our TURNIGY 9X system as we flash each unit in our office before it is shipped.

And i am not sure how i would allocate the channels that you mention.

Thanks Dave

[Jumpy07]

Ok .. its running Turnigy software.. 

This is the normal channel layout

1. Aileron
2. Elevator
3. Throttle
4. Rudder
5. Gear (Gyro)
6. Aux1 (Pitch)
7. Aux2
8. Aux3

[robshaw]

It wouldnt do any harm if you just plugged it all into your flight controller connected it to mission planner or whatever config software you used and just waggled the sticks to see what moved on the screen. Just swap RX plugs accordingly.

[davethepitch]

Thank you for the info as that is exactly what i wanted to know without having the manual handy which is on my laptop downstairs i think there is one channel they recommend not to use with a Naza but i cannot remember where i read it.

I am going to be fitting this RX to my Naza lite so i want to make sure i get the right information on the connections before i start so i will need to know which connections from the Turnigy RX go into the Naza including the 3 way switch as i need it all for reference.

Thank you and any further information and help will be greatly appreciated.

Dave