3d Printing Service
Printing 3d Forum
Started by davethepitch, Wednesday,June 26, 2013, 17:50:58
Quote from: KK1W on Wednesday,June 26, 2013, 19:02:41 I checked the page you referenced and the links work for me. It appears the ';release notes'; point to the v1.0 user manual too so no need to download that one twice.Hello Jim i have got the links to work as i have reinstalled Firefox and it seems to have cured it so no problem there anymore. I think you';re relatively new at this? Take your time and go through the manual step by step, it is reasonably well written. Be sure to LEAVE OFF THE PROPS until you are sure you have it setup correctly. These things can bite you in the butt faster than you can say, ';oh crap';!I will definitely remove the props as i have already been bitten once by my carbon fibre props a few months ago when an ESC packed in and my quadcopter and it came at me and hit my hand and the nerves in my finger have not healed although the wound has. The only thing in the manual that seems out of date is the boot up LED sequence. It should go through a series of red/yellow/green, then four greens, then into groups of four yellow until it ';warms up';. This step can take a few minutes, be patient.That';s all i need is a boot up sequence of colours as i am colour blind so i will have to get my friend to help there. :embarrassedI would get it working without GPS to start, then add it in later. Same goes for programming IOC and failsafe. One function at a time and it is easier to trouble shoot.Good luck Dave, they really fly quite well,Jim
Page created in 0.377 seconds with 42 queries.