v2 board flight modes

[ktnch]

Got an futaba f8tg set up 2 switched with a little mixing to have a single 6ch switch, struggling to get the flight modes to work on the crius, any info would be great

[ktnch]

Sorted it after days of watching vids and trial and error, think we need the pdf amending a little for newbies.

So receiver 1-4 - crius 8,9,10,11. then receiver 5 to crius 12 for flight modes.

I was trying to send the flight modes through ppm pin, also enabled it in the sketch and still wouldnt work, also found a great vid for the futaba f8tg twin switch mixing for 5-6 flight modes