3d Printing Service
Printing 3d Forum
Started by Bad Raven, Monday,November 11, 2019, 07:38:52
Quote from: ched on Monday,November 11, 2019, 14:05:04 There seem to be some short (20cm) extensions on ebay: http://bit.ly/2q5dJwDThats about the shortest commonly available, but useless for my purpose, as I'm talking mm not cm! That one's about 7.5" or about the length of an average European male xxxxx ........... (Never mind! )If you look at the pictures of my "yellow peril" you will likely see one of what comes with the Aurora 90 boards in use, though you'll only see the USB socket end. In that case the extensions have a differing small board socket and plug, so its actually also used as a converter to conventional USB micro, but USB micro plug to USB micro socket are sometimes rarely supplied with quads or boards.It's not moulded over plug or socket, and has individual fine wires, no overall insulation to stiffen and bulk, in all drastically reducing bulk/weight, and its overall length is only 35mm. It's just enough to get the USB access on a FC Board away from things like spacers, props, etc.They were particularly useful when some Naze boards had a rear mounted socket and it wasn't convenient to rotate the board, but still relevent today.
Page created in 0.094 seconds with 42 queries.