APM Power Module wiring ?.

[peter_a]

Hi , I want to use one of these Power Modules on my AIO v2 to act as a ubec plus for current voltage sensing.

http://www.unmannedtechshop.co.uk/uav-components/uav-sensors/apm-power-module-xt60-connector.html

"all through a 6-pos cable."

Is there a pin out from this module ?, because to me you only need 4 wires , + ( 5 v ), - ( gnd ) , volts , amps .

[Jumpy07]

Its not that great a bit of kit..   very low current..  so prob not worth the hassle..
Better using an Attopilot and a 5v UBEC

[peter_a]

it`s the current and voltage sensing I`m after really after , the ubec part is for free .

very low current.

For it will only be powering the Rx and the AIO board ( no servos ) , I would n`t think 2.5 amps is a problem ?.

[cubmanky]

Did you have any luck with this?  Looking to do the same.

[peter_a]

No , just to a naza lite .

[sevet]

The power module is for the APM, with the Attopilot 90A I get great results on Crius V2,  Attopilot 90A can have bigger cell count batteries that the power module can';t handle.

Also I use all my ESCs BECs to distribute the load:

1st ESC is only for the Crius FC
2nd ESC for my RX
3rd ESC - GPS and Telemetry
4th ESC - MinimOSD

That way you don';t draw too much power from the ESCs becs which are not that great.