3d Printing Service
Printing 3d Forum
Started by dean19794, Tuesday,March 12, 2013, 10:31:57
Quote from: Jumpy07 on Tuesday,March 12, 2013, 11:02:24 Are you in stabalize mode ? If so try dropping stabalize Roll P to 4.0 (Roll, Pitch and Yaw will change at the same time)
Quote from: Gaza07 on Tuesday,March 12, 2013, 19:26:33 Hi Dean I only sent you that screen as a example of where to change the rate P I didn';t mean for you to copy it all to your but if its working no harm done I will still lower the rate P values if your still getting the wobbles, just take em take a bit at a time
Quote from: Gaza07 on Tuesday,March 12, 2013, 19:50:49 Notice how much lower your rate P is
Page created in 0.174 seconds with 43 queries.