crius se v2 setup

[fruitsalad]

im in process of setting up my micro quad from a kk2 board to a crius se v2.
ive loaded 2.1 multiwii to board,using default pids and only set up for level at mo..
all good flying quite good needs a bit of trimming..

now im going to use my dx7 i have aux2 on 3 way switch and aux1 on gear switch,which flight modes are usefull and those not so..
theres quite a few there as im learning this stuff which should i use..

thanks all..

[fruitsalad]

all sorted after reading intake of umpteen pages..
went for 3 way switch with level,alt hold and carefree modes.
not much tuning needed got it flying lovely,alt hold not bad, happy with the results..
must say first time using and setting up multiwii, been easier than i expected.. ::) ::)

[Gaza07]

Multi Wii is a very stable platform and has a huge following and a great dev team 
I';m pleased to hear its all going well for you   

[fruitsalad]

trying to upgrade my se v2 board to multiwii 2.2 v.
in the caption box at the bottom it says this when its done uploading,what does it mean???
avrdude - stk500- getsync() -not in sync  resp=0x30

[Gaza07]

It means its failed have you selected the correct board type in the arduino app tools  you should have it set for
Pro mini 16mhz 5v 

[fruitsalad]

yes thats the board type i selected..

[Gaza07]

Delete the lot and use fresh copies of the files this some times works 

[fruitsalad]

i taxed the wifes laptop for halfhour,it loaded up fine on it..

[Gaza07]

Ive had so many people with this sort of problem and when they use fresh copies of the app and firmware it goes away  I have no clue what causes it but just know it works if you just renew the lot 

[JT]

 I know this thread is a couple of months old but if I try to upload anything to my FC(or indeed any arduino) with the bluetooth module or gps nav board connected I get the avrdude not in sync thing, unplug them and it will upload fine.

[Gaza07]

Thats normal if I';m reading you right because the blue tooth and ftdi share the same port you have to unplug the the blue tooth from a AIOP to be able to upload to it to