Head tracking problem

[robshaw]

Good morning folks,

So Ive been playing around with setting up my fat shark attitude sd goggles head tracking function last night (oh I remember the days when I would be out partying on a saturday night). 

After much playing around, including soldering a link into my brand new turnigy 9xr  I managed to get it working. Or at least I thought I did.

Unfortunately as soon as the tracking is enabled, the rest of the channels seem to disable themselves.  Either that or my crius AIOP just locks out.  When I monitor the radio calibration on mission planner, the channels are all working happy until I enable the head tracker by pressing the head tracker button . Head tracker kicks in nicely but the rest of the controls lock up.

Im using as mentioned, a turnigy 9xr, CRIUS AIOP, Frsky DJT telemetry tx module, Frsky V8FR2 rx.

When I connect the USB to the CRIUS to monitor it goes nuts and gives me the blue screen of death because I think its puling to much current from the USB port (its ok without head tracker). So I connect it with my 3DR telemetry device.

Any ideas would be gladly accepted guys.

[robshaw]

An update to this problem, it appears to be channel 7 thats killing the rest of it. If I disable the channel 7 movement (tilt) it seems to work ok.  Very weird.....

[Gaza07]

Thanks for the update Rob sorry I could offer any advice but your boldly going places ive never been before 

[robshaw]

SOLVED 

Seems I was putting too much load on the output of the CRIUS with 2 servos plus everything else.  Requires a separate battery to power receiver..

[Gaza07]

Nice one Rob I';m sure this will help some one else 

SOLVED 

Seems I was putting too much load on the output of the CRIUS with 2 servos plus everything else.  Requires a separate battery to power receiver..