3d Printing Service
Printing 3d Forum
Started by Jazzz, Wednesday,August 12, 2015, 10:19:48
Quote from: Jazzz on Wednesday,August 12, 2015, 10:19:48 Is enyone using the self level mix on rc911 firmwear or eny other self level mix like horizon mode I would like to turn the settings down to make the self level less snappy But keep the same sharp feel to the tx Is it done with pi settings or in the self level rates settings My fc is set inside my quad and is hard to get to so just testing is very difficult I have read friskle has his settings very low just wondering how it was done
Page created in 0.216 seconds with 42 queries.