minthrottle set

[Commando]

Hello, 
I had the same problem with that guy, http://youtu.be/ULNf645lI-M
In video comments are writing about minthrottle settings.
Also talking about filter.(OK about it)
What do you thing is the problem?
What is your suggestion for my motors\esc minthrottle settings?
My parts are:
turnigy
propdrive
35-36
910KV
Esc
hobby king
40A SBEC

I want a stable fpv flight (no acrobatics)
My accident was on mission crashed so bad!
Do you thing that may be  a wrong PID settings?
Cheers!

[fruitsalad]

is your f/c hard mounted or on some kind of vibration damping..
try lowering the low pass filter in multiwii config.

[Commando]

Its mounted on a homemade antivibration base with 4 bumpers but are for 150g weight each. Should I change bumper? 
I like not lower the filter because as I understand suspend corections of {I}

[fruitsalad]

mines on 3m doublesided pads.
i have my multiwii set on 42 low pass filter,flies fine after adjusting the pids..

[Commando]

mines on 3m doublesided pads.
i have my multiwii set on 42 low pass filter,flies fine after adjusting the pids..

Good that helps!!!! Thanks!!!

[fruitsalad]

dont forget to calibrate the escs..
comment out the do not fly then load to board..
then reload put the // back on do not fly.

[Commando]

Thanks already done!