Welcome to Multi-Rotor UK. Please login or sign up.

Tuesday,July 07, 2020, 06:13:17

Login with username, password and session length

Shoutbox

Andy7:
04 Jul 2020 13:16:48
VIDEO or it didn't happen!! :) Nice going though, keep it up!
Bad Raven:
02 Jul 2020 19:46:48
 ~~
whoelseisbored (LiamHowe89):
02 Jul 2020 17:45:19
Sounds basic but I'm happy with it  :laugh:
whoelseisbored (LiamHowe89):
02 Jul 2020 17:45:05
Managed a split s :D
badger1:
28 Jun 2020 12:29:49
BF GPS Rescue mode configured - what could possibly go wrong?   :o
badger1:
27 Jun 2020 21:07:37
and can't make it back to where you take off from   :laugh:
badger1:
27 Jun 2020 21:07:04
it's too windy if you fly downwind
Bad Raven:
27 Jun 2020 20:51:32
I have done Dynamic Soaring in over 55mph, and quad flying in over 25mph with the right equipment.
whoelseisbored (LiamHowe89):
26 Jun 2020 16:44:24
How windy is too windy? :hmm:
whoelseisbored (LiamHowe89):
25 Jun 2020 22:58:29
YASSSS!! Flew a full 2 packs and no motors going nuts on me!  :D
Members
  • Total Members: 8117
  • Latest: DarylW
Stats
  • Total Posts: 198962
  • Total Topics: 20050
  • Online Today: 30
  • Online Ever: 530
  • (Tuesday,June 26, 2012, 08:34:46 )
Users Online
Users: 0
Guests: 24
Total: 24

Theme Changer





thumbnail

3d - Printworx

Printing 3d Forum

Warning/indicator LED's and buzzer

Started by Paulham, Thursday,January 17, 2013, 19:20:24

Previous topic - Next topic

Paulham

Hi guys,
Isit possible to wire some LEDs into the aio pro board so that armed status and gps fix is easily seen , also a buzzer would be good?

Simular to this http://diydrones.com/profiles/blogs/led-low-battery-warning-on

Thanks
Paul

bunnygirl80

Hi Paul,

You can connect your own buzzer, but you have to be careful that you don';t overload and damage the FC board. This is why it says on the board plans not to connect a buzzer directly. The boards are normally 5v, the buzzer can vary but as an example might be 3v. So, there is a 2v surplus. You have to use Ohm';s Law to work out what resistor you need to use the buzzer. Ohm';s Law states Resistance = Source Voltage - Sensor Voltage / Current of Sensor. So, FC board is 5v - Buzzer 3v = 2v / Buzzer 10mah = 200ohm Resistor. You can put the resistor either side of the buzzer cables. Once you';ve done this, just enable the BUZZER code in your FC software. I';m in the middle of enhancing the standard MultiWii software to add tones and volume to indicate things.

Good luck.

Always smile because you never know who could be falling in love with it. :) Drone Operator in North Wales. www.aerialworx.co.uk