3d Printing Service
Printing 3d Forum
Started by davezx6r, Sunday,November 02, 2014, 19:45:45
Quote from: davezx6r on Sunday,November 02, 2014, 22:00:55 Hi Danny Its Dave....bought ur 450 cheers for the reply, ive hopefully attached a pic of the pin out on my CC3d board for ya to have a nose at....totally different!!! lol
Quote from: DarrellW on Monday,November 03, 2014, 12:51:10 Looks like the signal wires are wrong to me as well - signal on Spektrum is normally on top!
Quote from: Hands0n on Monday,November 03, 2014, 10:46:41 Hey Dave, that wiring looks a bit wrong to me You seem to have the wiring completely reversed ::)Think of Thro as Pin 1, Aile as Pin 2 and so on ... So the cable should be attached to the RX as follows ...1. Thro --> Black-Red-White (tri-wire)2. Aile --> Blue3. Elev --> Yellow4. Rudd --> Green5. Gear --> Orange6. Aux1 --> Purple (or what looks like Brown in your pics)In the GUI you may need to tell the software the order of your channels, often abbreviated to TAER. I cannot recall now, it was a little while back ... But as long as you slowly and diligently follow the Set Up wizard the chances are it will all work okay on first power up ::)
Quote from: davezx6r on Monday,November 03, 2014, 16:38:53 .... would I be right in assuming that with cc3d only 1 esc has the power an the other 3 need the red wire isolating ?
Page created in 0.162 seconds with 43 queries.