Crius AIO Pro V2 esc calibration.

[octebra]

Hi, I am building my first quad and I';m using a crius board, Afro 30 amp esc';s, Turnigy 2836/8 motors, Turnigy 8ch tx/rx and S3 lipo battery. When I calibrate with the rx with a 4 to 1 jig all motors run fine but when I reconnect to the board they are all mixed up, they seem to start in sequence as I increase the throttle. Has anyone come across this and if could you pleeezzzz Help.
Thanking you in advance.

[dirtyharry]

have you calibrated the accelerometers on the board?

Also to calibrate motors on a crius you load the sketch with the " // "  brackets removed from " // calibrate motors"

Its near the bottom of the config page.

Re-load , let it run , then re-load with "//" back in.

ps you don';t need to calibrate afro esc';s according to the developers of them.

[octebra]

Thankyou very much for taking the time to reply, I have read a lot of material on quads but have not seen anything on calibtating the accelerometers could you please enlighten me. I will also calibrate the esc';s via multiwii.
Have carried out calibration of esc';s, accelerators and magnetometers, I have attached 2 pics of gui with min and max throttle. Should thet look like this.
Many thanks again.