Hello ! Retract landing help.

[Poseidone]

Hello everyone, I';m new to the forum . I would like to add a tbs discovery and retractable landing gear tarot and I wonder if someone has already done this and it has pictures . thank you

[Rommie]

im in the process of doing this so will post up pics once complete unless you finish before me lol

[Poseidone]

im in the process of doing this so will post up pics once complete unless you finish before me lol

OK thanks. I bought a sheet of carbon 2mm thick to accommodate the retractable landing gear in the bottom of the frame.

I put the question of where exactly the gear , if put in the middle between the front and rear arms or put it in the center of gravity

[Poseidone]

[ched]

I am sure you have this covered but I assume you have insulated the pcb above the carbon fibre board you used to attach the retracts to? Carbon fibre is conductive so without insulation it could short the pcb.

Looks like a nice install nice and neat.

[Poseidone]

I am sure you have this covered but I assume you have insulated the pcb above the carbon fibre board you used to attach the retracts to? Carbon fibre is conductive so without insulation it could short the pcb.

Looks like a nice install nice and neat.

Thank you , the support that I have realized is abs , then insulation . I did not want a hole in the frame to avoid cutting the ski circuit , I used the same holes of the motors and center supports . Only problem, the legs are too close , I have to find a way to adjust the limit engine

[Rommie]

I';m still looking at ways to do this that don';t look out of place for 1 and secondly are wide enough apart to accommodate a 3 axis gimbal underneath