Source for 1s hv 300mah ph2.0 lipos?

[ched]

Anyone know anywhere that have any 1s HV 300mAh ph2.0 lipos in stock and are either in UK or ship to the UK?
Cheers.

[Bad Raven]

HobbyRC have 350mAh in stock. I have been using 333mAh on my two Mobula6 with no issues, and have ordered some.

[ched]

HobbyRC have 350mAh in stock. I have been using 333mAh on my two Mobula6 with no issues, and have ordered some.

I found those but wos worried they would be too heavy for the mob6 after finding the mob7 a handful with 2x 450mAh.
If you are currently using 333mAh and they are OK I think the 350mAh will be fine. I will wait for my new FC to arrive then order some, cheers.

[Bad Raven]

I found those but wos worried they would be too heavy for the mob6 after finding the mob7 a handful with 2x 450mAh.
If you are currently using 333mAh and they are OK I think the 350mAh will be fine. I will wait for my new FC to arrive then order some, cheers.

Mine should arrive on Friday.  I'll let you know.

[Bad Raven]

OK, delivery arrived, and 350mAh 1S GAONENG from HobbyRC briefly tested.

No time now to do a full duration of flight test, but the hover point is seemingly unchanged by the greater weight, always a good sign. Punch out is marginally reduced, only a small amount though, and might make holding power through moves easier to get right!

I cannot accurately weigh them and give figures as my small weigh scales have decided to give random amount readings sometimes and not zero after a measurement at other times (and no, not batteries). 

Unsurprisingly they feel a bit heavier, but there is nothing in the weight or size between the 333 and the 350. They are of course much longer but at least do not intrude into the duct area.

One thing with both the 333 MyLiPo.de ones and these 350 Gaoneng is that they are rigid plug on end cap, and the short captive lead on the quad will not allow them to be fitted in balance if at all without strain.

A socket to plug extension lead is therefore required (which I made up many weeks back from a charger lead and an old battery lead, but then I have oodles from the chargers supplied every five batteries pack and the worn out E010 batteries!).

HTH. 

[ched]

Great info BadRaven, thanks.
My new FC arrived this morning so hopefully I can get that setup and bound fairly easily.
Interesting about the end caps, I did wonder if caps would be better as I have had some 1s lipos with thin cables. I'm sure I can knock up a connector should I need too 

Cheers again.

[ched]

Cheers Bad Raven. Ordered a few today  Thanks

[ched]

The batteries arrived today. They are a little longer than the happy model 300mAh lipos but they dont have cables just the plug directly on end of the battery. They fit the mobula6 no problem, OK so they sit a little far forward and actually stick out the front a few mm. 
Flight time is about 4:30 which is great. I didn't notice any difference in weight but they have a lot less sag and still have decent punch when getting towards 3.3v.
I am impressed.
They came from hobbyrc.

Cheers Bad Raven.