Print Page - Bind problem X4R-SB and Q S7S

Title: Bind problem X4R-SB and Q S7S
Post by: tellblom on Saturday,January 12, 2019, 15:42:51

Hi,
First of all, I'm a complete newbie on this so please bare with me.

Tried to bind a X4R-SB to my Taranis Q X7S and the first time it succeded but with a fast flashing green led. I read somewhere that you need to rebind so I try that now without success. When I try to bind again the green led is solid but the Red one is flashing. What coukld be the problem?

Both transmitter and receiver is EU versions.

Anyone that could help me?

Title: Re: Bind problem X4R-SB and Q S7S
Post by: Two-Six on Saturday,January 12, 2019, 16:12:25

It could be that your radio is still in bind mode or you haven't power-cycled the receiver with the radio on. Is this any help?
http://www.youtube.com/watch?v=32v5helQqrE

Title: Re: Bind problem X4R-SB and Q S7S
Post by: tellblom on Saturday,January 12, 2019, 16:25:00

Thanks for the video, that was better than the one I used. When I restart the transmitter and recover I'm back to the fast flashing green led as it should be.

For someone else its good to now that there is two manuals on this model online. One where it says it should be solid green and the other when it says flashing is the right status.

Multi-Rotor UK

Equipment / Tx Rx / Servo's / Telemetry / Batteries / Motors / Esc's / Props / Camera Gimbals => Transmitters / Receivers => Topic started by: tellblom on Saturday,January 12, 2019, 15:42:51