Fault with new DJI Zenmuse H3-2D

[kamon1]

I have just fitted my new Zenmuse H3-2D Gimbal to my DJI 450 Flame wheel with Naza-M V2 operated by a Futaba T8J
When i plug in the Flame Wheel the Gimbal works fine stays level when you rock it side to side, but it turns and points to the ground
i have no control with my VR knob that i have set to ch5 to control the pitch of the camera.
All software is up to date. Any ideas please :?:
I am using a Go Pro Hero 3+
Connected with S-Bus lead on receiver

[Mudders]

Have you switched the gimbal on in the assistant software and set it to 400hz?

[kamon1]

It is turned on in the software I will try 400hz

[Flying Monkey]

If you have the Zenmuse connected via the GCU to the Naza then the tilt control is on X1 (from memory).  You don';t use the gimbal screen at all.

You need to open naza assistant, choose basic and rc and calibrate the X1 channel that will give you the range of movement for the tilt.

[shaktar]

also have a look In the DJI Zenmuse_H3_2D Assistant program, that shows the tilt bar too.

The gimble control in the Naza Assistant is for servo gimbles only so just turn that off, it has no effect on this.

[kamon1]

 :notworthy:All i needed to do was Calibrate X1 job done ;D