FC with BF OSD, current sensor, blackbox, UK supplier ?

[ched]

My new Omnibus F4 V2/V3 seems to have a busted video chip http://www.multi-rotor.co.uk/index.php?topic=21681.msg197584#msg197584
So I guess I will have a chat with BangGood and hopefully get a refund so I can get a UK one to be in the air sooner.

So looking for recommendation.
I would like:
BetaFlight OSD
Current sensor (using 4in1 esc)
Blackbox (ideally via microSD)
35x35 (30.5x30.5 mounting)

Any ideas on FC and uk supplier?

Cheers

[Cheredanine]

Sounds like another omnibus mate, got an asguard otw but suspect you already have escs
What cam are you using, loads you can use if you move osd to a piggy osd

[ched]

It';s the RunCam Split so no inbuilt OSD well not that is accessible.
Already have esc (4in1) so limited to single power wires to esc. So not ideal for the FC with pads at corners for 4 separate escs. Not too keen on FC with built in power distribution as full current flowing through whole board. The Omnibus F3 V2 pro just flows +ve through shunt resistor so less likely to give interference.
Cheers.

[GdLookinMingeR]

https://www.makeitbuildit.co.uk/matek-f405-osd-betaflight-built-in-osd 
looks like a bargain :-)
Regards
Jay

[ched]

https://www.makeitbuildit.co.uk/matek-f405-osd-betaflight-built-in-osd 
looks like a bargain :-)
Regards
Jay

Cheers, it does look like a bargain. Unfortunately it works best with the pdb and I only have 2mm to spare in stack.

[Cheredanine]

https://www.makeitbuildit.co.uk/matek-f405-osd-betaflight-built-in-osd 
looks like a bargain :-)
Regards
Jay

Good call, I tried one of the matek ones, it worked fine, until I crashed it very hard