What did the postman bring today?

[Powernumpty]

ASW28 GLIDER

Hope you have a big field and tie the battery down well (oh and have some spoiler options).

[Jake Bullit]

Flaps and Southport beach

[ched999uk]

Hadn';t seen that, about time too, I hate putting a Taranis in a small rucksack whereas the small FlySky i6 types are fine.
Just hope it is competitive on price because if FlySky get some more telemetry sensors going like vario, gps etc they will have cornered the value market.

Just to let you know there is a thread on RCGroups forum where a couple of people are working on i6 telemetry. https://www.rcgroups.com/forums/showthread.php?2486545-FlySky-FS-i6-8-channels-firmware-patch%21/page88
It';s still in development but there are screen shots showing gps data on the i6 tx screen!!!!

[NoviceQuad]

I do believe my new HMF U580 Pro frame arrived today including motors and ESC';s for my new build.

Stuck at work until 4 though 

[Doug]

A pair of FRSKY XM Rx';s can';t believe just how small they are  16.5x10.25 mm

Makes the XSR look totally huge in comparison

[Revs]

A pair of FRSKY XM Rx';s can';t believe just how small they are  16.5x10.25 mm

Makes the XSR look totally huge in comparison

Does it have telemetry? I guess not as there is no s.port

[Cheredanine]

Does it have telemetry? I guess not as there is no s.port

none of the xm have telemetry, the xm+ is probably the prefered Rx, the range on the xm is shorter

[Doug]

none of the xm have telemetry, the xm+ is probably the prefered Rx, the range on the xm is shorter

Agreed but for what this is for (an Armattan Bumper) it should be fine.

[Cheredanine]

Agreed but for what this is for (an Armattan Bumper) it should be fine.

Yeah sorry should have clarified, the xm is probably for e micro quad, xm+ for mini

[Doug]

Yeah sorry should have clarified, the xm is probably for e micro quad, xm+ for mini

No apologies needed mate you weren';t to know what they were going to be used for anything any bigger and I would be going for the XSR or X4r-sb rx';s anyway?

[Saleem]

Set of brotherhobby tornado 1407 3600,furious fpv kombini and props from makeitbuildit.
 

[Revs]

Behold! 63/37 solder...

[attachimg=1]

EDIT: This is the worst solder I have ever used. Barely melts at 300c. Simply refuses to solder on a PDB at 450c. Avoid!

[Gav]

A set of Hubsan H501S props (because I tried to FPV it in the woods and lost videosignal almost immediately after the 1st corner of our 250 race track).

think the Hubsan could do with a skew planar wheel antenna upgrade 

 

[hoverfly]

Behold! 63/37 solder...

[attachimg=1]

Delicious, can';t beat a bit of lead in yer pencil.   

[shawdreamer]

4x racerstar 20amp esc
1x 8ch reciever
martek pdb
heap of 4 blade dal';s
various bit of wires
tx03 AIO cam
2x 4s 65c 1600mah lipo';s
4x 2600kv racerstar motors

and a new dilemma....

should I build my new design tough250 V2 or  re-vamp my current pod-racer design....... lifes never simple!

maybe.... if I duplicate the order again I can fool the missus into thinking its just a duplicate paypal receipt of the same order and I can just do both!!!

[Reman]

It';s been like a late Xmas for me this week. It';s been a cluster of orders from BangGood that have all been turning up together. So far I';ve received.......

2x MOY RXA2 receivers for some brushed builds I';ve been slowly collecting bit';s for,

4x Flysky X6B RX';s because they were cheap enough and I really want to revisit some of my earlier "Rats nest wiring" builds now I';m getting better at clean installs,

A shed load of various reasonably chunky gauge power wire,

Another 4 Aomway cloverleaf antennas because I found the last few VTX';s I';d bought were SMA and I didn';t have any spare aerials to go on them,

A (Large) handful of prop nuts,

Some FPV cam mounts,

A couple more of the 20A Racerstar RS20Ax4 ESC';s and 6 Racerstar BR2205 motors because I';ve found I quite like my "Built from spares" hex now and don';t want to rob bit';s off of it if I ended up needing them elsewhere,

More XT60U plugs and sockets than I think I';ll ever need,

And a pretty little Liantian LT130 frame because I';d found that my Realacc MM130';s motors were REALLY struggling with the frames weight. Despite being off work with flu today I managed to transfer all the electronics across as a pre wired clump from the 100g MM to the 32g LT frame in about 45 minutes, and it fly';s SOOOOO much better in it';s new home....... And all with only minimal snot on it ! LOL !

I also got a couple of packs of those crazy "Rainbow Rose Seeds" to give to my mum....... Mainly because the pictures of them look like some trippy as hell photoshop job. I just want to see if they can really look like this?

[Digit]

A fully Kissed 6 inch QAV-R

[hoverfly]

A fully Kissed 6 inch QAV-R

First time I';ve heard it called that!!

[Revs]

First time I';ve heard it called that!!

It';s the go-to phrase at RCG Enjoy Digit, hope it works out. Me and KISS don';t get along 

[Bad Raven]

Two FrSky XM';s and two XM+';s............... damn FlySky FS-A8S';s are coming off and going back to them, total rubbish (unlike most of their other gear which I';m very happy with)

[Elmattbo]

An aomway switchable vtx with pigtail. Solves a lot of build headaches in one go!


Sent from my iPad using Tapatalk

[Vinny]

A few bits over the last few days.

[Digit]

It';s the go-to phrase at RCG Enjoy Digit, hope it works out. Me and KISS don';t get along 

I don';t like how I can';t have stick arming and airmode at the same time. I';m not doing crazy inverted spins or even use the full stick throw the majority of the time so I';m not worried about disarming midair.

[Revs]

[Revs]

Parcel Force actually on form today. First bits for the Bumper quad..

[attachimg=1]

[atomiclama]

It kinda ruined things for me and I didn';t fly for 5 months.

Thought you';d been a bit quiet around here

[Revs]

Thought you';d been a bit quiet around here

Yeah, but I';m back in force now 5" sorted, 6" under way and an Armattan Bumper en route!

[Brainzzzz]

DU BRO prop balancer. .

[Bad Raven]

A plastic box of nylon studs/spacers/nuts/screws, dead exciting!

[Jazzz]

Received today at 130 in the air by 330